ID: Q121243
2.60a MACINTOSH
The information in this article applies to:
When a FoxPro installation already exists, the FoxPro Setup program starts in maintenance mode, prompting you to add or remove components of your current installation, reinstall FoxPro, or remove all FoxPro components of the current FoxPro installation.
Below is a full description of the maintenance mode Setup program.
Welcome to the Microsoft FoxPro 2.6 Setup installation maintenance
program.
This program allows you to make changes to your current
installation of Microsoft FoxPro 2.6 Setup. Please select one of
the following options:
Button Description
Add/Remove Add new components, or remove installed components, from
your current installation.
Reinstall Repeat your last installation, restoring missing files
and settings.
Remove All Remove all previously installed components.
Exit Setup (No description)
NOTE: The Reinstall button installs FoxPro in the same folder. To install
FoxPro in a different folder, choose Remove All, then choose the Exit Setup
button. Run Setup again. This time, Setup does not start in maintenance
mode and will perform a fresh installation, prompting you for the folder in
which to install FoxPro.
The dialog box contains two list boxes. The list box on the left has the following description:
Components Not Yet Installed
Check any items from this list you would like to install.
The list box on the right has the following description:
Installed Components
Check any items from this list that you would like to remove.
The items listed in either list box are:
- Arial
- Courier New
- FoxFont
- WingDings
- Times New Roman
- FoxPrint
- Microsoft System Information
- Readme Files
- Distribution Kit
- Library Construction Kit
- Connectivity Kit
Keywords : kbsetup
Version : 2.60a
Platform : MACINTOSH
Last Reviewed: May 21, 1998