PRB: "No PARAMETER Statement Found" in .EXE File

ID: Q111059

2.50 2.50a 2.50b | 2.00 2.50 2.50a 2.50b

WINDOWS          | MS-DOS

kbprg kbprb

The information in this article applies to:

Microsoft FoxPro for Windows, versions 2.5, 2.5a, 2.5b, 2.6 and 2.6a
Microsoft FoxPro for MS-DOS, versions 2.0, 2.5, 2.5a, and 2.5b

SYMPTOMS

When you are running an .exe file built with FoxPro, the following error message occurs when you try to execute a cross-tabulation:

   No PARAMETER statement found.

NOTE: In FoxPro 2.0 for MS-DOS, the error that occurs is:

   File '' does notexist.

CAUSE

The cross-tabulation program is being executed by referencing a variable that has an incorrect value. For example,

   DO (_genxtab) WITH "Query"

when the variable _genxtab has not been initialized.

RESOLUTION

Set the value of the variable being used before issuing the DO command. For example,

   _genxtab="GENXTAB.PRG"
   DO (_genxtab) WITH "Query"

MORE INFORMATION

Steps to Reproduce Behavior

1. Put the following commands into a program file called TEST.PRG:

      **This program uses the CUSTOMER.DBF file from the
      **\FOXPROW\TUTORIAL directory.
      **
      SELECT Customer.ono, Customer.state, Customer.ytdpurch;
        FROM Customer;
        GROUP BY Customer.ono, Customer.state;
        ORDER BY Customer.ono, Customer.state;
        INTO CURSOR SYS(2015)
      DO (_GENXTAB) WITH 'Test'
      BROWSE NOMODIFY PREFERENCE Test

2. Type the following in the Command window:

      BUILD PROJECT test FROM Test.prg
      MODIFY PROJECT test

3. Open the project file and choose Build and then choose Build

   Executable.

4. Try to execute the .exe file outside FoxPro, either from the Windows

   Program Manager, or from the MS-DOS prompt if it is an .exe built with
   FoxPro for MS-DOS.

The error message "No PARAMETER statement found" occurs. To correct this error, do the following:

1. Modify the program and make the following command the first line in

   the program:

      _GENXTAB="GENXTAB.PRG"

2. Type the following command in the Command window:

      BUILD PROJECT test FROM test.prg,genxtab.prg

3. Open the project and build the executable again.

If you now run the executable file outside FoxPro, the cross-tabulation program will be run as expected.

Additional reference words: FoxDos FoxWin 2.00 2.50 2.50a 2.50b xtab crosstab errmsg err msg KBCategory: kbprg kbprb KBSubcategory: FxprgBrowse

Keywords          : kberrmsg FxprgBrowse 
Version           : MS-DOS:2.0,2.5,2.5a,2.5b; WINDOWS:2.5,2.5a,2.5b,2.6,2.6a
Platform          : MS-DOS WINDOWS

Last Reviewed: November 24, 1998