"Interrupt Jumper Missing" Error Message
ID: Q38754
The information in this article applies to:
- Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, and 8.x
- Microsoft Bus Mouse, version 1.0
SUMMARY
When you install the Microsoft Mouse Driver and the Microsoft Bus Mouse,
you may receive the following error message:
Interrupt jumper missing
This error can be caused by any of the following;
- The interrupt selected on the J4 jumper is conflicting with existing
hardware. If the IRQ vector is being used by anything else, this
message appears.
- The J2 jumper on slot 8 is not set to normal (as it should be).
- The interface card is defective. This can only be verified by
installing the mouse and software on another machine and testing the
mouse.
KBCategory: kbsetup kbhw
KBSubcategory:
Additional reference words: 8.00 8.10 8.20 bus mouse errmsg
Last Reviewed: September 16, 1996