ID: Q75216
8.x 9.00 MS-DOS kbhw
The information in this article applies to:
Installing a BallPoint Mouse for MS-DOS and Windows modifies the AUTOEXEC.BAT and Windows 3.0 SYSTEM.INI files, as well as create a new program group in Windows.
To have Windows load the original MOUSE.DRV, do the following:
1. In the AUTOEXEC.BAT file, remove the following line:
set mouse=c:\ballpt
2. In the [boot] section of the SYSTEM.INI file, change the line
mouse.drv=
to
mouse.drv=mouse.drv
If the BallPoint Mouse was attached to a PS/2 style port when
installed, look for the [386Enh] section in SYSTEM.INI.
Change the line
keyboard=
to
keyboard=*vkd
3. From the MS-DOS prompt of the Windows subdirectory, type "setup"
(without the quotation marks). Make sure that the "Mouse:" line
reflects the type of mouse that was attached before the BallPoint
Mouse.
4. To remove the newly added BallPoint Mouse Windows group,
delete each icon inside the group, then delete the group.
KBCategory: kbhw
KBSubcategory: win30 win31 wfw wfwg
Additional reference words: 3.00 8.00 trackball remove
Keywords : win31 win30 wfwg
Version : 8.x 9.00
Platform : MS-DOS
Last Reviewed: September 18, 1996