Interrupt Setting for the IBM PS/2 Model 30

ID: Q28497

The information in this article applies to:

• Microsoft InPort Mouse, version 1.x
• Microsoft Mouse Driver for MS-DOS, versions 6.x, 7.x, and 8.x

SUMMARY

When you install the mouse InPort interface card on a PS/2 Model 30, Microsoft recommends that you set the J4 interrupt to jumper 2 or 3.

Please check that other peripheral boards are not using the same interrupt setting as the mouse. Do not use pair 5 for the setting.

The IBM product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability.

KBCategory: kbsetup kbhw kb3rdparty KBSubcategory: Additional reference words: 8.10 8.00 setup install 3rdparty

Last Reviewed: September 16, 1996