ID: Q115982
1.00 1.10 2.00 3.00 WINDOWS kbsetup kbenv
The information in this article applies to:
When you run the Setup program for one of the programs listed above, there are certain rules that are followed for copying and removing files on your hard disk drive. If you run the Setup program again, after installing the program (maintenance mode), you can choose to install additional components or remove components from your system. The following is a list of the rules that the Setup program uses.
The Setup program uses the following rules when copying and removing files on your hard disk drive:
1. Setup should not remove anything that it cannot replace.
a. Setup can remove older versions of components that you ship if and
only if setup has the information needed to remove the component.
b. Programs may REQUIRE that a shared component be upgraded because of
version incompatibilities.
2. Shared components can be removed if the Setup program knows how to
remove and reinstall them.
3. There are four states that a component can be in: Not Installed, To Be
Installed, Installed, and To Be Removed. There are two possible actions:
Install and Remove.
4. Without system support, the Setup program cannot be sure that the
configuration hasn't changed. You may have deleted or changed a file by
hand, or another program may have replaced shared/common files.
Keeping a database of what is installed is not secure.
KBCategory: kbsetup kbenv
KBSubcategory: offwinsetup
Additional reference words: 1.00 1.10 2.00 3.00 4.00 4.20 4.30 5.00 6.00
6.00a 7.00 8.00 97 office97 office8 macppt winppt
Keywords : offwinsetup
Version : 1.00 1.10 2.00 3.00
Platform : WINDOWS
Last Reviewed: January 17, 1997