DOCUMENT:Q86674  11-OCT-1999  [win95x]
TITLE   :Windows Err Msg: Standard-Mode Switcher Is Not Running
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:WINDOWS:3.1,3.11
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows versions 3.1, 3.11 
-------------------------------------------------------------------------------

SYMPTOMS
========

You may receive the following error message during Windows Setup or when running
MS-DOS-based applications in standard or 386 enhanced mode:

   Standard mode switcher is not running

CAUSE
=====

Problem Occurs During Setup
---------------------------

If any programs are placed below the [run] section in the SETUP.INF file, Windows
Setup starts the application after completing the installation of Windows. If an
entry for an MS-DOS-based application appears here, you will receive the error
message noted above.

MS-DOS-based applications cannot be run if standard-mode Switcher (DSWAP.EXE) is
not loaded. WIN.COM starts DSWAP.EXE, so when Windows is started, you can run
MS-DOS-based applications. Because the graphical portion of Windows Setup is
started by DOSX.EXE, not WIN.COM, DSWAP.EXE is not loaded during Setup.

Problem Occurs When You Run MS-DOS-Based Applications
-----------------------------------------------------

If the problem occurs when running an MS-DOS-based application or MS-DOS Prompt,
you will need to re-create WIN.COM.

The standard-mode Switcher (DSWAP.EXE) is initialized by WIN.COM when you start
Windows. If WIN.COM is corrupted or damaged, DSWAP.EXE may not be initialized
properly. If DSWAP.EXE is not loaded, or is loaded incorrectly, you will get the
error message noted above.

RESOLUTION
==========

Re-creating WIN.COM
-------------------

You can re-create WIN.COM by reinstalling Windows, or by selecting a different
video driver and then switching back to the original. To cause WIN.COM to be
updated by switching video drivers:

1. Run Windows Setup from MS-DOS Prompt at the WINDOWS directory.

2. Change the Display to a different resolution, usually the next lowest option.
   For example, if you are using VGA, install for EGA. The resolution you choose
   does not matter because you will not actually be running Windows with the
   driver.

3. Follow the instruction on the screen to install the new display driver.

4. Run Windows Setup again.

5. Change the Display back to its original setting.

When you change the Display setting, WIN.COM is re-created. The disadvantage of
this procedure is the additional video driver and font files will remain on your
hard drive in the Windows SYSTEM subdirectory, unless you manually delete them.

Additional query words: 3.10 3.11 err msg network /n /a workstation novell banyan vines lan manager std

======================================================================
Keywords          :  
Technology        : kbWin3xSearch kbZNotKeyword3 kbWin310 kbWin311
Version           : WINDOWS:3.1,3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.