Windows NT Does Not Detect SCSI Drive ID 6

Last reviewed: May 6, 1997
Article ID: Q96270

The information in this article applies to:

Microsoft Windows NT operating system version 3.1

SUMMARY

Most SCSI hard disk drives are set to ID 6 by default. Windows NT checks for ID 1 first and then ID 0. If Windows NT cannot detect your SCSI drive, set your SCSI drive ID to 1, 0 (preferably), or any other ID but the one the SCSI controller is using.

Additional query words: prodnt
Keywords : kbhw nthw
Version : 3.1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 6, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.