WD: Word Err Msg: "Not Enough Memory to Run Word" in Windows NT

ID: Q103114

The information in this article applies to:

Microsoft Word for Windows, versions 2.0, 2.0a, 2.0a-CD, 2.0b, 2.0c, 6.0, 6.0a, 6.0c
Microsoft Windows NT operating system version 3.1
Microsoft Windows NT Advanced Server version 3.1

SYMPTOMS

When you start a 16-bit version of Word for Windows in Windows NT, you may receive the following error message, even though there is plenty of available memory:

   There is not enough memory to run Word.

There are four known situations that can cause this error:

1. The default printer is unavailable.

2. There is insufficient disk space in the Word directory.

3. There is insufficient disk space in the TEMP or startup directory.

4. If you are running on a network, you do not have Print permission

   for the default printer.

RESOLUTION

Below are instructions for resolving each of the causes listed in the previous section.

Default Printer Unavailable

The printer pointed to by the default printer driver may be unavailable. Run Print Manager and delete all printers and printer connections. Restart Word. Alternatively, test the printer connections by printing to each installed printer from Notepad.

Insufficient Disk Space in Word Directory

Word uses the default program directory for some of its internal temporary files. There should be at least 4 megabytes (MB) of free disk space in this directory.

Insufficient Disk Space in TEMP or Startup Directory

The TEMP environment variable set in the AUTOEXEC.BAT file may be missing or pointing to a location where there is insufficient disk space to create Word's temporary files. From the System portion of Control Panel, check that the User Environment includes a valid TEMP variable. If the Word startup directory is different from the default, especially if it is in the same logical drive as the Windows NT paging file, there may be insufficient disk space to open Word.

No Print Permission for Default Printer

To run Word under Windows NT, you must have Print permission with the default printer. When you start Word, the program queries the printer for information about its supported fonts, paper sizes, and so forth. If you do not have permission to print, Word cannot obtain this information, so it fails to start.

For permission to print, ask your network administrator to perform the following steps (NOTE: You cannot change your own permissions unless you are a Windows NT Administrator or Power User):

1. Start the Windows NT Print Manager.

2. Select the window representing the printer so that its window

   appears on top of all other printer windows.

3. From the Security menu, choose Permissions.

4. In the Permissions window, check for any entries that specifically

   state "No Access" for the user or for a group that the user belongs
   to. Remove any entries that deny the user access. If an entry
   denies a group the user belongs to, either remove the entry or
   remove the user from that group.

5. Check to make sure that there is at least one entry that grants the

   user or a group the user belongs to the permission of Print or Full
   Control. If there is no such entry, you must add one.

6. Choose OK.

This change in permissions will take effect immediately.

KBCategory: KBSubcategory: Additional query words: winword2 3.10 virtual 16ap 2.0 2.0a 2.0a-CD word6 2.0b 2.0c 6.0 rights out of memory error run running winword unstable

Keywords          : kbprint
Version           : 2.0 2.0a 2.0a-CD 2.0b 2.0c 6
Platform          : WINDOWS

Last Reviewed: February 5, 1998