DOCUMENT:Q95941  30-JUL-2001  [lanman]
TITLE   :Err Msg: "Cannot Find File LMRSETUP.EXE" with RAS Setup
PRODUCT :Microsoft LAN Manager
PROD/VER:
OPER/SYS:
KEYWORDS:

======================================================================
SUMMARY
=======

In certain situations, you may need to create a set of 360K floppies in order to
install RAS (Remote Access Services) on an MS-DOS workstation. The instructions
on page 32 of the "Remote Access Service Administrators Guide" explain the steps
necessary to create a 360K disk set for installing RAS on an MS-DOS
workstation.

RAS 1.1 differs from the previous version by creating a disk set for both a LAN
MANAGER client and a Windows for Workgroups client. You will be prompted for
four 360K disks during the MK360RAS disk creation. After following the steps
outlined on page 32, you are then prompted to run the Setup program on the
MS-DOS workstation. When you use these disks to run the Setup program, you may
receive the following error:

   Cannot find file LMRSETUP.EXE

At this point you will be returned to the MS-DOS prompt. After review of the
MK360RAS.CMD file, the LMRSETUP.EXE is in fact not copied to the Setup disk as
it should be. This file is 276416 bytes in size and will not fit on the 360K
Setup disk created by MK360RAS.CMD.

MORE INFORMATION
================

In this situation you will need to follow the steps outlined below in order to
successfully install the RAS 1.1 client on a MS-DOS workstation:

1. Create a directory on the hard drive of the workstation (for example,
   C:\RAS).

2. Copy the contents of the Setup disk created in step 3 on page 32 of the RAS
   Administrators Guide. You can use the following command to copy all files on
   this disk:

   " copy a:*.* c:\RAS " (without the quotation marks)

   Note: the example above assumes that you are copying from drive A to the RAS
   directory on drive C.

3. Once the files have been copied, you will need to retrieve the LMRSETUP.EXE
   file from the directory on the server where the 360K disks were created.
   Place the file on a disk and copy this file into the directory created in
   step 1 above.

Once all the files have been copied into the RAS directory, you can successfully
run SETUP.EXE and install the RAS client software. When you are prompted for
disk #2, enter the location for the disk (for example, A: or B: ) and Setup will
continue normally.

Microsoft has confirmed this to be a problem in RAS version 1.1. We are
researching this problem and will post new information here in the Microsoft
Knowledge Base as it becomes available.

Additional query words: wfw wfwg 1.10 2.20 ras1.1

======================================================================
Keywords          :  

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2001.