ACC: No AutoRepeat with GoToRecord/Next and DoMenuItem
ID: Q95645
|
The information in this article applies to:
-
Microsoft Access versions 1.0, 1.1, 2.0, 7.0, 97
SYMPTOMS
Novice: Requires knowledge of the user interface on single-user computers.
The AutoRepeat property for command buttons does not work in conjunction
with the GoToRecord/Next macro action for moving to successive records on
a form. In other words, if your form uses command buttons instead of the
record selector buttons to move from record to record, the AutoRepeat
property does not repeatedly run a macro that performs a GoToRecord/Next
action.
Also, the AutoRepeat property fails under the same circumstances when you
use the DoMenuItem/Form/Records/GoTo/Next macro action. To rerun the macro,
you must click the command button again.
CAUSE
This is correct behavior for these macro actions. Here are two points that
need clarification before the cause can be explained:
- OnClick property: The macro under the OnClick property of a command
button normally will not run until you push and let up the command
button with the mouse pointer in the command button's region. The
exception is when the command button's AutoRepeat property is set to
Yes. In this case, the macro set for the OnClick property of the
command button runs when the button is pushed and the mouse pointer
is in the command button's region.
NOTE: The OnClick property is called the OnPush property in version 1.x.
- Focus: Several macro actions change the focus. For example,
GoToControl, GoToRecord, OpenForm, OpenTable, and ApplyFilter
change the focus.
Therefore, if a command button's OnClick property macro changes the
focus, for example, to the next record, then the command button has lost
the focus; that is, when you click the command button, the click does
not apply to that command button anymore because the focus has changed.
It's as if you had moved the mouse pointer off the command button while
pressing the mouse button, as if the command button moved out from under
the mouse pointer right before you pressed the mouse button.
STATUS
This behavior is by design.
MORE INFORMATION
Steps to Reproduce Behavior
- Start Microsoft Access.
- Open the sample database Northwind.mdb (or NWIND.MDB in versions 1.x
and 2.0).
- Create a new macro as follows and save it as AutoRepeatTest:
Macro Name Action
--------------------------
AutoRepeatTest GotoRecord
AutoRepeatTest Actions
--------------------------
GoToRecord
Object Type: Form
Object Name: Customers
Record: Next
- Open the Customers form in Design view.
- Drag the macro you have just created onto the form to create a
command button.
- Set the AutoRepeat property of the command button to Yes. Note that
the command button's OnClick property is set to the name of the
macro.
- View the Customers form in Form view to browse the form and click the
command button. Note that each time you click the command button, the
record selector moves to the next record. When you click and hold down
the command button, you would expect Microsoft Access to scroll rapidly
to the last record in the table, but this does not happen. Instead, the
record selector moves to the next record only, regardless of the
command button's AutoRepeat property setting.
However, if you add a macro that uses a different macro action, such
as Beep, to the form, the AutoRepeat action works as expected. This is
because Beep does not change the focus.
Keywords : McrActn
Version : 1.0 1.1 2.0 7.0 97
Platform : WINDOWS
Issue type : kbprb
Last Reviewed: March 19, 1999