DOCUMENT:Q226322  10-AUG-2001  [winnt]
TITLE   :How to Use RRAS DOD w/Third-Party Unnumbered Connections
PRODUCT :Microsoft Windows NT
PROD/VER:winnt:4.0
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Routing and Remote Access Service Update for Windows NT Server version 4.0 
 - Microsoft Windows NT Server version 4.0 
-------------------------------------------------------------------------------

SUMMARY
=======

When Dial on Demand (DoD) in Routing and Remote Access Service (RRAS) is used to
connect to a terminal server, the terminal server may give out an IP address on
the same subnet as the LAN that the RRAS server is connected to. As a result,
the clients on the local LAN and the remote side of RRAS server fall within the
same IP network.

A number of hardware routers/terminal servers allow you to do this with
"Unnumbered connections". RRAS can be configured to work with these kinds of
routers, so that you do not have to subnet the range of IPs that you have been
given from an Internet Service Provider (ISP).

MORE INFORMATION
================

In RRAS, when dialing a third-party terminal server or router that supports
unnumbered connections, configure the following:

 - Use an arbitrary static pool. An example of an arbitrary static pool to use
   would be 10.0.0.248/29.

 - Create the DoD connection. Configure the DoD connection to dial into a
   "non-Windows NT router" that expects you to know your IP address.

 - Add a static route. When connecting your LAN clients to the Internet, the
   typical entry would be a default gateway route. This default gateway route is
   associated with the DoD connection to the ISP. This can also be a specific
   route for remote networks.

 - On the DoD connection, prerequest the IP the router wants to give you. Do not
   use "server assigned" address. In order for unnumbered connections to work,
   it is important to know the IP address that will be assigned by the
   router/terminal server

 - Change the IP on the LAN network card so that it is not the same as the IP
   you are requesting from the DoD (this is important - routers that support
   unnumbered connections seem to want these to be the same, but RRAS does not.
   So make sure the IP bound to the network adapter is not the same as the one
   you are prerequesting, although it does have to be the same Network ID). For
   example, if the IP assigned by the dial-up device was always going to be
   131.107.0.1, then the IP assigned to the network adapter could be
   131.107.0.2. This would work well.

Additional query words:

======================================================================
Keywords          :  
Technology        : kbWinNTsearch kbWinNT400search kbWinNTSsearch kbWinNTS400search kbWinNTS400 kbAudDeveloper kbRRASNTSearch kbRRASNT400
Version           : winnt:4.0
Issue type        : kbinfo

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2001.