DOCUMENT:Q75033  17-DEC-2000  [msdos]
TITLE   :Microsoft MS-DOS Upgrade Minimum Installation
PRODUCT :Microsoft Disk Operating System
PROD/VER:MS-DOS:5.x,6.0,6.2,6.21,6.22
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft MS-DOS operating system versions 5.0, 5.0a, 6.0, 6.2, 6.21, 6.22 
-------------------------------------------------------------------------------

SUMMARY
=======

If you do not have enough free space to install Microsoft MS-DOS 5 or later
Upgrade even after removing unnecessary files, you can perform a minimal
installation. A minimal installation does NOT do the following:

 - Expand and copy nonsystem files directly from the upgrade disks to your hard
   disk.

 - Copy your previous nonsystem files to the OLD_DOS directory.

A minimal installation creates the following:

 - CONFIG.NEW and AUTOEXEC.NEW files

 - MS-DOS version 5.0 or later system files (IO.SYS, MSDOS.SYS, COMMAND.COM) on
   the hard drive

 - An OLD_DOS directory containing only a README.NOW file

MORE INFORMATION
================

To perform a minimal installation, do the following:

1. Create a set of working disks.

   For more information about how to create working disks, see the section titled
   "Installation on Floppy Disks" in Chapter 2 of the version 5.0 "Microsoft
   MS-DOS Getting Started" manual.

2. After you create the working disks, back up all of your current MS-DOS files
   by copying them to another directory or disk.

3. Remove any memory resident programs from your AUTOEXEC.BAT file.

4. Insert Disk 1 - Setup in drive A.

5. Type "a:setup /m" (without the quotation marks).

6. When Setup is finished, press ENTER to restart your computer.

7. Because you have the working disks of MS-DOS 5.0, you can selectively copy
   nonsystem files of MS-DOS 5.0 to the previous MS-DOS directory. Do not mix
   the previous MS-DOS nonsystem files with the new ones in the same directory.
   An "Incorrect DOS Version" error message will be displayed if the previous
   MS-DOS nonsystem file is executed.

8. Compare CONFIG.SYS and AUTOEXEC.BAT with CONFIG.NEW and AUTOEXEC.NEW. Make
   necessary modifications.

9. Restart the computer. Make sure there is no disk in the floppy drive.

Additional query words: 6.22 5.00 5.00a 6.00 6.20

======================================================================
Keywords          :  
Technology        : kbMSDOSSearch kbMSDOS621 kbMSDOS622 kbMSDOS620 kbMSDOS600 kbMSDOS500 kbMSDOS500a
Version           : MS-DOS:5.x,6.0,6.2,6.21,6.22

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.