DOCUMENT:Q97605 21-NOV-1999 [msdos] TITLE :Running Apex II Sketching Program from a DoubleSpace Volume PRODUCT :Microsoft Disk Operating System PROD/VER:MS-DOS:6.0,6.2,6.22 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft MS-DOS operating system versions 6.0, 6.2, 6.22 ------------------------------------------------------------------------------- SYMPTOMS ======== This information applies to both Microsoft DoubleSpace and Microsoft DriveSpace. For MS-DOS 6.22, use DRVSPACE in place of DBLSPACE for commands and filenames. When you run Apex II Sketching Program after installing DoubleSpace, the program demonstration may run instead of the full program. CAUSE ===== According to Apex technical support, a batch file is used to run the Apex II Sketching Program instead of the demonstration. The copy protection scheme used by Apex makes it necessary to launch the program with a batch file if you are using DoubleSpace. WORKAROUND ========== To work around this problem, create an APEX.BAT file and edit the LICENSE.BAT file. To do this: 1. Determine the host drive for the compressed drive that contains the Apex software. To do this, type "DBLSPACE /LIST" (without the quotation marks) at the MS-DOS command prompt and then press ENTER. NOTE: Steps 2, 3, and 4 assume the host drive is H. 2. Change to the DoubleSpace-compressed drive that contains the Apex software. For example, type "C:" (without the quotation marks) at the MS-DOS command prompt and press ENTER. 3. Change to the Apex directory, delete the MOVE.COM file, and copy the LICENSE.EXE file. To do this, type the following at the MS-DOS command prompt (press ENTER after each line): " cd\apex del move.com copy license.exe h:\license1.exe" (without the quotation marks) 4. Use MS-DOS Editor to create a batch file named APEX.BAT in the Apex directory with these entries: @echo off h: cd\ apex.exe 5. Using MS-DOS Editor, edit the LICENSE.BAT file so it reads as follows: @echo off c: cd\apex h:\license1 %1 copy h:\license.* NOTE: The period (.) and asterisk (*) are important on the COPY line. You can now run the Apex II Sketching Program by typing "apex" (without the quotation marks) at the MS-DOS command prompt. The Apex product included here is manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding this product's performance or reliability. Additional query words: 6.00 6.20 (demo) 3rdparty double space dblspace ====================================================================== Keywords : Technology : kbMSDOSSearch kbMSDOS622 kbMSDOS620 kbMSDOS600 Version : MS-DOS:6.0,6.2,6.22 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 1999.