DOCUMENT:Q155502  17-DEC-2000  [win95x]
TITLE   :Manual Default Gateway Does Not Override DHCP Lease
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:Win95
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows 95 
-------------------------------------------------------------------------------


SYMPTOMS
========

When Windows 95 is configured to be a DHCP client, TCP/IP communication to some
remote network segments is sporadic or completely dysfunctional.

CAUSE
=====

When you configure the TCP/IP protocol properties (in the Network Control Panel
tool), you have manually entered an IP address in Installed Gateways (on the
Gateway tab). The program Winipcfg.exe confirms that this manually configured
default gateway is not being used. The DHCP-assigned default gateway is used
instead of the one listed in the TCP/IP properties in the Network Control Panel
tool.

RESOLUTION
==========

You can run the program Route.exe from an MS-DOS command prompt (command window)
to manually override the default gateway that was assigned in the DHCP lease.
For example, if DHCP assigned a default gateway of 199.199.10.1, yet you need to
override with 199.199.10.50, you would use the following commands:

1. View the routing table using the following command:

      c:>  ROUTE  print

2. Your default gateway will show up at the top of the list:

     Net Address   Netmask   Gateway Addr     Interface     Metric
         0.0.0.0   0.0.0.0   199.199.10.1   199.199.10.69        1

3. Delete the existing default gateway using the following command:

      c:>  ROUTE  delete  0.0.0.0

4. Add your new default gateway using the following command:

      c:>  ROUTE  add  0.0.0.0  MASK  0.0.0.0  199.199.10.50

5. Confirm the new default gateway you entered in the previous step:

     Net Address   Netmask   Gateway Addr     Interface     Metric
         0.0.0.0   0.0.0.0  199.199.10.50   199.199.10.69        1

NOTE: The new gateway address will not be accepted if Windows 95 is unable to
reach the gateway using the IP address and Subnet mask of the installed network
card(s).

STATUS
======

Microsoft has confirmed this to be a problem in Windows 95. We are researching
this problem and will post new information here in the Microsoft Knowledge Base
as it becomes available.

Additional query words: DG D.G.

======================================================================
Keywords          :  
Technology        : kbWin95search kbZNotKeyword3
Version           : Win95

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.