DOCUMENT:Q64859  27-NOV-1999  [win95x]
TITLE   :Testing the Connection to a PostScript Printer
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:WINDOWS:3.0,3.0a,3.1,3.11
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows versions 3.0, 3.0a, 3.1, 3.11 
-------------------------------------------------------------------------------

SUMMARY
=======

This article provides instructions for determining if your PostScript printer
(such as an Apple LaserWriter) is connected properly to the computer.

MORE INFORMATION
================

Windows 3.1 and 3.11
--------------------

Microsoft Windows 3.1 installs TESTPS.TXT in your WINDOWS\SYSTEM subdirectory for
testing your PostScript output. To use this file, copy it to the port connected
to the PostScript printer. The following is an example:

   copy c:\windows\system\testps.txt lpt1

The output at the printer should be a single page, with the following information
in the lower-left corner:

   Max Printer VM (KB):
   Max Suggested VM (KB):
   Baud Rate:
   Data Bits:
   Parity:
   Stop Bits:
   Flow Control:

Windows 3.0 and 3.0a
--------------------

At the MS-DOS command prompt, type the following:

   " COPY CON COMx:
   showpage " (without the quotation marks)

NOTE: After each line (command) above has been entered, press CTRL+Z and then
ENTER. COMx: refers to the physical port where the PostScript printer is
connected. You can substitute COMx for COM1, COM2, LPT1, LPT2, and so on.

You will be returned to an MS-DOS command prompt. If the connection between the
printer and the computer is good, a blank page ejects from the printer.

To test the processor of the PostScript printer, type the following commands at
the MS-DOS command prompt:

   " COPY CON COMx:
   initgraphics
   /ZapfChancery-MediumItalic findfont 48 scalefont setfont
   200 432 moveto
   (This is a test) show
   showpage" (without the quotation marks)

NOTE: After each line (command) above has been entered, press CTRL+Z and then
ENTER. COMx: refers to the physical port where the PostScript printer is
connected.

You will be returned to an MS-DOS command prompt. If the connection has been
properly made, a sheet prints with the words "This is a test."


KBCategory: kbprint
KBSubCategory:

Additional query words: tshoot 3.00 3.0 3.0a 3.00a 3.1 3.10 3.11

======================================================================
Keywords          :  
Technology        : kbWin3xSearch kbZNotKeyword3 kbWin300 kbWin300a kbWin310 kbWin311
Version           : WINDOWS:3.0,3.0a,3.1,3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.