How To Read CRS Registry Flags To Determine Configuration

ID: Q187548

The information in this article applies to:

Microsoft Commercial Internet System version 1.0
Microsoft Site Server version 2.0

SYMPTOMS

When the Content Replication System (CRS) is configured with the following CRS Command line utility, server2 and server3 will never get added:


   CRS EDITPROJ <Project> destination=server1 server2 server3

Server1 may also not get fully added.

The Destination value is located in the Content Replication System project information key:


   HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\CRS\Projects\<Project Name>

This can cause the CRS <Project Name> to fail.

RESOLUTION

To work around this problem, use the Content Replication System Web Administrator program or upgrade to Site Server version 3.0

If this behavior is a serious problem, then apply the fix described below.

STATUS

Microsoft has confirmed this to be a problem in Microsoft Commercial Internet System version 1.0 SP1 and Site Server version 2.0.

A supported fix is now available, but it has not been fully regression- tested and should be applied only to systems experiencing this specific problem. Unless you are severely impacted by this specific problem, Microsoft recommends that you wait for the next Service Pack that contains this fix. Contact Microsoft Technical Support for more information.


Keywords          : 
Version           : WINNT:1.0,2.0
Platform          : winnt 
Issue type        : kbbug

Last Reviewed: July 20, 1999