XCON: How to Move X.400 Connectors Between Bridgeheads Within Same Site

• Microsoft Exchange Server, version 5.5

SUMMARY

This article discusses the procedure to be followed in a situation where the X.400 Connectors must be moved from one bridgehead server to another bridgehead server within the same site. This may be necessary because of load balancing or in case the first bridgehead crashes or needs to be removed form the site.

MORE INFORMATION

To move X.400 Connectors from one bridgehead server to another within a site:

1. Find out which X.400 Connectors need to be moved to another bridgehead.



2. Configure these X.400 Connectors on the new bridgehead in accordance with the information in the following Microsoft Knowledge Base articles:




Q169159 XCON: X.400 Connector Configuration Checklist

Q165111 XCON: Configuring X.400 Connector between Two Exchange Servers

Q199326 XCON: Configuring X.400 Connectors to Communicate Through a Firewall

3. Recalculate the routing on the new bridgehead server.



4. Test the moved X.400 Connectors and make sure they are fully functional.



5. After you are absolutely sure that the moved X.400 Connectors are fully functional, remove the X.400 Connectors on the first bridgehead.



6. Recalculate routing on the first bridgehead.

Additional query words:

Keywords          : 
Version           : winnt:5.5
Platform          : winnt 
Issue type        : kbinfo 

Last Reviewed: August 5, 1999