ID: q170064
The information in this article applies to:
When an MCIS Internet News Server (INS) fails due to an unexpected situation, such as loss of power, disk failure, and so forth, you must rebuild the server using the command:
nntpbld -c -G -e
MCIS 1.0 Nntpbld.exe is not fully optimized for quick server recovery.
Nntpbld.exe was modified to include two new command line switches that can greatly reduce the amount of time to rebuild a server.
The new command line switches are not be listed when you enter this command at a command prompt:
nntpbld -?
-x If this switch is specified, nntpbld will avoid rebuilding the XIX
index files. Currently, nntpbld deletes all XIX files in its first
pass through the news tree and then rebuilds them while scanning
NWS articles. Because XIX files are almost as stable as NWS files,
in most cases it makes sense to not delete and rebuild them. This
saves the overhead of lots of WriteFile() calls.
NOTE: This switch should be used when it is reasonably certain
that
Only the hash tables are corrupted. The safest course of action,
if
the extent of the corruption is not known, is to not use this
switch.
-w n Where n is the number of threads to use. The maximum number of
threads is 64. Using 0 for the value of n results in the number of
threads being 2 times the number of processors.
Microsoft has confirmed this to be a problem in Microsoft Commercial Internet System version 1.0. This problem has been corrected in the latest U.S. Service Pack for Microsoft Commercial Internet System version 1.0. For information on obtaining the Service Pack, query on the following article in the Microsoft Knowledge Base:
ARTICLE-ID: Q183062
TITLE : MCIS 1.0 Service Packs 1 and 2 Information
Version : WinNT:1.0
Platform : winnt
Hardware : ALPHA x86
Issue type : kbbug
Solution Type : kbfixLast Reviewed: November 20, 1998