PRJ98: Setup.wri Lists Incorrect Command Line Switches for SetupID: q184672
|
The instructions in the "Run the Client Installation in Batch Mode" section of the Setup.wri file incorrectly lists the following command lines:
Typical setup /Q1 /B1Using the /B3 switch will actually result in a Workstation installation and using the /B4 will actually result in a Typical installation.
Complete setup /Q1 /B3
Workstation setup /Q1 /B4
Uninstall setup /Q1 /U
Use the following switches when you perform a client installation in batch mode, installing Microsoft Project from a server:
Typical setup /Q1 /B1For more information about setting up Microsoft Project 98, refer to the file named Setup.wri. This file is usually installed in the default Microsoft Project folder:
Complete setup /Q1 /B2
Workstation setup /Q1 /B3
Uninstall setup /Q1 /U
C:\Program Files\Microsoft Office\OfficeNote that the folder name will be different if you did not select the default location during setup.
Typical setup /Q1 /B1NOTE: In SR-1, the /B3 switch will also result in a Workstation install, however other problems may be associated with it's use and it is recommended to avoid using that switch.
Complete setup /Q1 /B2
Workstation setup /Q1 /B4
Uninstall setup /Q1 /U
Microsoft has confirmed this to be a problem in the versions of Microsoft
Project listed above.
This problem was corrected in Microsoft Project 98 for Windows, Service
Release 1 (SR-1).
For additional information about obtaining and installing SR-1, please see
the following article in the Microsoft Knowledge Base:
ARTICLE-ID: Q185102
TITLE : PRJ98: How to Obtain and Install MS Project 98 SR-1
Additional query words:
Keywords : kbsetup kbdta projwin
Version : WINDOWS:98
Platform : WINDOWS
Issue type : kbbug
Last Reviewed: July 14, 1999