After Installing NetShow, IIS May Stop RespondingID: Q185875
|
When you install Microsoft Windows NT Server NetShow 3.0 Services or
enable HTTP streaming after a NetShow installation, Microsoft Internet
Information Server (IIS) or other Web servers may fail to start or cease
serving Web pages via Hypertext Transfer Protocol (HTTP).
In cases where you are running IIS, the following error message may be
present in the Event Viewer:
Event ID: 115
The service could not bind instance 1. The data is the error code.
The NetShow 3.0 Services allows you to use HTTP streaming to serve on- demand content. This feature can be enabled during setup. If this functionality is enabled on a computer that is also running another application that uses HTTP, such as IIS 4.0, NetShow may interfere with that services normal operation.
Disable HTTP streaming on the NetShow server by performing the following steps:
If the service that NetShow is interfering with is Microsoft IIS 4.0, it
is possible to configure IIS 4.0 in a manner that will allow you to run
NetShow 3.0 Services with HTTP streaming enabled on the same box.
For additional information, please see the following article in the
Microsoft Knowledge Base:
Q184317 Running IIS and NetShow Server with HTTP Streaming Enabled
Web servers or other applications that use HTTP typically use TCP port 80.
TCP port 80 is the port that has been reserved for HTTP traffic. When
working with TCP/IP under Microsoft Windows NT server, a port that is in
use by a service to accept inbound connections, cannot be used by another
service.
Additional query words:
Keywords :
Version : WINNT:3.0
Platform : winnt
Issue type : kbprb
Last Reviewed: June 23, 1999