DOCUMENT:Q169117  21-MAY-2000  [exchange]
TITLE   :XFOR: MS Mail Users Send SMTP, NDR, 2375, 2113 Inconsistently
PRODUCT :Microsoft Exchange
PROD/VER:winnt:4.0,5.0
OPER/SYS:
KEYWORDS:kbusage

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Exchange Server, versions 4.0, 5.0 
-------------------------------------------------------------------------------

SYMPTOMS
========

When Microsoft Mail users send SMTP mail through the Internet Mail Service (or
Internet Mail Connector in version 4.0), they may sometimes get a non- delivery
report (NDR) that reads:

   Delivery to (SMTP:user1@domain1.com) failed.
   Reason: unable to transfer diagnostic: no route to intended MS Mail
   recipient.

Where user1 is not a Microsoft Mail recipient but any recipient on the Internet.
The Microsoft Mail users are, however, receiving local mail and SMTP mail with
no problem.

One of the following six errors might be found in the Event Viewer:

Error1:

   5/22/97 12:55:53 PM MSExchangeMSMI Error Session Error 2375 N/A TRADE MS
   Mail Connector Interchange has detected a configuration problem. No
   mailbag on the MS Mail Connector Post Office was found for recipient:
   SMTP:rlaporte@sierrahitek.com in the message with message id
   CA/TCAHQPO/00000C9D.

Error2:

   5/22/97 12:55:53 PM  MSExchangeMSMI  Warning    NDR 2371   N/A  TRADE
   Invalid recipient(s) found in CA/TCAHQPO/00000C9D. Generating
   non-delivery report.

Error3:

   5/22/97 12:55:53 PM  MSExchangeMSMI  Information Routing   2444 N/A
   TRADE
   Message ID <00000C9D> processed from INQUEUE

Error4:

   MSExchangeMSMI Warning NDR 2371 N/A TRADE Invalid recipient(s) found
   in CA/TCAHQPO/00000C9D. Generating non-delivery report.
   MSExchangeMSMI Information Routing 2444 N/A TRADE Message ID <00000C9D>
   processed from INQUEUE

Error5:

   MSExchangeMSMI Error Session Error 2375 N/A TRADE MS Mail Connector
   Interchange has detected a configuration problem. No mailbag on
   the MS Mail Connector Post Office was found for recipient:
   SMTP:rlaporte@sierrahitek.com in the message with message id
            CA/TCAHQPO/00000C9D.

Error6:

   Event ID 2113 Message ID delivered to exchange. ID 2375 invalid
   recipients found in Exchange PO. No mailbag found on MS Mail
    connector PO was found." Delivery to  (SMTP:rlaporte@sierrahitek.com)
   failed.
   Reason: unable to transfer diagnostic: no route to intended MS Mail
   recipient.

CAUSE
=====

After translating a recipient address, MS Mail Connector Interchange was unable
to route the message to a Microsoft Mail post office. A non delivery report is
generated for this message. This may be caused by the existence of an SMTP
address space in the MSMail Connector. If it exists, then messages intended for
the IMS will randomly be sent to the MSMail connector. This is caused by the
steps taken by the MTA to determine routing. If outbound SMTP messages are
delivered to the MSMail connector, an NDR is generated because there is no
MSMail postoffice that matches the address.

RESOLUTION
==========

To resolve this problem:

1. Do not enter the SMTP address type in the address space property page of the
   MS Mail Connector, unless SMTP mail is being sent via the MS Mail Connector
   to an SMTP gateway or "Gateway to AT&T" on the Microsoft Mail side.

2. Ensure the proper MS Mail Gateway Access components are set up at the MS Mail
   Connector post office.

3. In the Exchange Server Administrator program, double-click the MS Mail
   connector and select the Address Space tab. If there is an address of SMTP
   type, select it and click Remove.

Additional query words:

======================================================================
Keywords          : kbusage 
Technology        : kbExchangeSearch kbExchange500 kbExchange400 kbZNotKeyword2
Version           : winnt:4.0,5.0
Issue type        : kbprb

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.