Windows Setup Was Unable to Update Your System Files

ID: Q125480


The information in this article applies to:


SYMPTOMS

One of the following symptoms may occur:

After you restart the computer, you receive the following message:
Windows Setup was unable to update your system files

This may be caused by virus detection that is built-in to your machine, or by virus detection software running on your system.

To disable built-in virus detection you will need to run the configuration program for the CMOS that came with your machine, or contact your machine manufacturer.

To disable virus-detection software that you have running on your system, you may need to remove the lines that start the program from your AUTOEXEC.BAT or CONFIG.SYS files.

After you have disabled the virus detection software, re-start your machine and re-run Windows Setup. Once you have successfully completed setup, it is okay to re-enable the virus detection software.


CAUSE

Some computers include a feature that prevents applications from writing to the boot sector. Such features are normally in the form of anti-virus protection set in your computer's CMOS settings. If anti-virus protection is enabled, Windows cannot complete its installation, or it does not load properly.


RESOLUTION

Disable the anti-virus feature in your computer's CMOS settings, and then reinstall Windows. Once you have successfully installed Windows, re- enable the anti-virus feature.

For information about accessing your computer's CMOS settings, please consult your owner's manual or your computer manufacturer.

NOTE: In order to disable Compaq's SafeStart Manager in the CMOS settings, you must upgrade the BIOS to at least version 2.26b.


MORE INFORMATION

The following computers have been found to display this problem:



Additional query words: antivirus locks freezes hang


Keywords          : kberrmsg kbsetup diskmem win95 win98 
Version           : 95
Platform          : WINDOWS 
Issue type        : kbprb 

Last Reviewed: January 15, 1999