Error Message Running Emergency Repair Process on a Computer with a Large IDE Hard Disk

ID: Q224087


The information in this article applies to:


SYMPTOMS

When you run the Emergency Repair process for Windows NT, the process may seem to finish very quickly, or you may receive the following error message:

Setup has determined that drive X: is corrupt beyond repair.

Setup cannot continue. Press F3 to exit.
Rebooting and choosing to repair the boot sector without using the Emergency Repair Disk generates the following message:
Windows NT Workstation Setup

Setup could not find a Windows NT installation to repair. Unless you provide the Emergency Repair Disk for the installation which you want to repair, Setup will not be able to repair it.


CAUSE

This situation is most likely to occur when the following conditions exist:


The Microsoft-supplied generic IDE driver (Atapi.sys) may not be fully compatible with drives larger than 8 GB. This issue affects only IDE-based drives that are 8 GB in size or larger.


RESOLUTION

To resolve this issue:

  1. Download the Atapi.exe file from the following Microsoft FTP server:
    ftp://ftp.microsoft.com/bussys/winnt/winnt-unsup-ed/fixes/nt40/atapi/ATAPI.EXE


  2. Copy the Atapi.exe file to a blank floppy disk. Run Atapi.exe on the disk. The new Atapi.sys file is extracted to the disk.


  3. Copy the updated Atapi.sys file to disk 3 of the Windows NT Setup disk, choosing Yes to overwrite the existing version of the file.

    NOTE: If you have access to the Windows NT 4.0 Service Pack 4 CD-ROM, you can copy the updated Atapi.sys file from the appropriate platform folder to disk 3 of the Windows NT Setup disks.


  4. Boot from the Setup disks supplied with the Windows NT installation media.


  5. When you reach the following screen just after inserting and running disk 3, press ESC:

    Windows NT Workstation Setup

    Setup needs to know if you have the Emergency Repair Disk for the Windows NT version 4.0 installation you want to repair. NOTE: Setup can only repair Windows NT version 4.0 installation.


Setup should then correctly identify and repair the installation.


STATUS

Microsoft has confirmed this to be a problem in the Microsoft products listed at the beginning of this article.


MORE INFORMATION

Windows NT 4.0 Service Pack 4 (SP4) has a new Atapi.sys file that allows drives to be formatted during Windows NT Setup. the SP4 versioni of the Atapi.sys file can also gain access to space beyond 8 GB on these IDE drives.

NOTE: The system partition containing the Ntldr, Boot.ini, Ntdetect.com, Ntbootdd.sys, and Bootsect.dos files is still limited to 7.8 GB whether or not the updated version of the Atapi.sys file is installed. For additional information, please see the following article in the Microsoft Knowledge Base:

Q114841 Windows NT Boot Process and Hard Disk Constraints
Note that the computer's BIOS must support and recognize drives larger than 8 GB for Windows NT to be able to use entire drive. You can verify this ability by running the computer's BIOS configuration routine or by contacting your computer's manufacturer.

For information about related issues, please see the following articles in the Microsoft Knowledge Base:
Q177257 STOP 0x0000000A or Difficulty Recognizing IDE CD-ROM Drives
Q183654 IBM DTTA-351010 10.1 GB Drive Capacity Is Inaccurate
Q197667 Installing Windows NT Server on a Large IDE Hard Disk

Additional query words: ERD corrupt FAT-32


Keywords          : kbenv kberrmsg kbhw kbsetup 
Version           : winnt:4.0
Platform          : winnt 
Issue type        : kbprb 

Last Reviewed: April 29, 1999