DOCUMENT:Q61306  04-NOV-1999  [utilities]
TITLE   :PRB: Browse Options Unavailable Under Strange Circumstances
PRODUCT :Microsoft Programming Utilities
PROD/VER:MS-DOS:1.0,1.1; OS/2:1.0,1.1
OPER/SYS:
KEYWORDS:kb16bitonly

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Programmer's Workbench for MS-DOS, versions 1.0, 1.1 
 - Microsoft Programmer's Workbench for OS/2, versions 1.0, 1.1 
-------------------------------------------------------------------------------

SYMPTOMS
========

Under certain circumstances, the Browse options within the Programmer's
WorkBench (PWB) may be unavailable. You can take all the steps outlined in the
documentation required to generate a Browse Database, but the Browse options may
be still grayed out.

CAUSE
=====

The most likely cause is an invalid CURRENT.STS file. This file can be found in
the INIT directory or the current working directory. CURRENT.STS is used to save
the PWB settings from session to session. If this file is in a form that is not
acceptable to the PWB, strange results may occur during use of the PWB.

One instance in which CURRENT.STS might become corrupt is in the case of a system
crash from within the PWB during a compile.


To determine if a corrupt CURRENT.STS is the cause of the problem, take the
following steps:

1. Invoke the PWB with the /DS switch to force it to ignore the CURRENT.STS
   file.

   Note: This will reset all switches within the environment that were previously
   recorded by CURRENT.STS.

2. Take the normal steps required for preparing a Browse database. (Set a
   program list, mark Generate Browse Information under the Browse options menu,
   and rebuild the project.)

Browse information should now be available. If disabling the CURRENT.STS does
remedy the situation, the only permanent solution is to delete the CURRENT.STS
file that is causing the problem.

RESOLUTION
==========

Two possible solutions are deleting the make file and letting the PWB regenerate
it, or deleting the CURRENT.STS file and resetting all the options for the
editor.

NOTE: Since deleting the CURRENT.STS file will result in the loss of all
environment settings, it is advisable to note any important settings you may
have set up before deleting the file.

Additional query words: 1.00 1.10 hang stop halt PWBIss

======================================================================
Keywords          : kb16bitonly 
Technology        : kbAudDeveloper kbPWBSearch kbZNotKeyword3 kbPWB100DOS kbPWB110DOS kbPWB100OS2 kbPWB110OS2
Version           : MS-DOS:1.0,1.1; OS/2:1.0,1.1

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.