DOCUMENT:Q180706 09-AUG-2001 [sna] TITLE :Incoming X.25 Host Connection Indicates Primary Link Role PRODUCT :Microsoft SNA Server PROD/VER::3.0,3.0 SP1,3.0 SP2,4.0 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft SNA Server, versions 3.0, 3.0 SP1, 3.0 SP2, 4.0 ------------------------------------------------------------------------------- SYMPTOMS ======== When an SNA Server X.25 connection is configured for Remote End: Host and Allowed Directions is configured for Incoming or Both Directions, the SNA Server notifies the X.25 link service that it has a primary link role when it should have indicated a secondary link role. The incorrect X.25 link role is reported to the X.25 link service in the SNA Server's Open(Link) request. This problem was found by Eicon Technology, though may occur with any X.25 link service supported by SNA Server. CAUSE ===== The SNA Server configuration DLL (SNACFG.DLL) was incorrectly defaulting the X.25 link role when the X.25 connection is configured to support incoming calls. This caused the SNA Server to indicate a primary link role in error. STATUS ====== Microsoft has confirmed this to be a problem in SNA Server versions 3.0, 3.0 Service Pack 1 (SP1), 3.0 SP2, and 4.0. This problem was corrected in the latest SNA Server versions 3.0 and 4.0 U.S. Service Packs. For information on obtaining these Service Packs, query on the following word in the Microsoft Knowledge Base (without the spaces): S E R V P A C K MORE INFORMATION ================ The SnaBase service must be stopped in order to apply the updated SNA Server configuration DLL (\system\SNACFG.DLL). Once the updated SNACFG.DLL is applied, the SNA Server Manager program must be run and the configuration file must be resaved. For additional information about a similar issue with Incoming SDLC connections, click the article number below to view the article in the Microsoft Knowledge Base: Q305160 Incoming SDLC Connections Log Event 182 and Fail to Activate Additional query words: ====================================================================== Keywords : Technology : kbAudDeveloper kbSNAServSearch kbSNAServ300 kbSNAServ400 kbSNAServ300SP1 kbSNAServ300SP2 Version : :3.0,3.0 SP1,3.0 SP2,4.0 Issue type : kbbug Solution Type : kbfix ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2001.