DOCUMENT:Q150643 19-FEB-2002 [ssafe] TITLE :PRB: Setting Wrong System Date Causes Lost Project History PRODUCT :Microsoft SourceSafe PROD/VER::4.0,6.0 OPER/SYS: KEYWORDS:kb3rdparty kbSSafe400 kbSSafe600 ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Visual SourceSafe, 16-bit, for Windows, versions 4.0, 6.0 - Microsoft Visual SourceSafe for Windows, version 6.0 ------------------------------------------------------------------------------- SYMPTOMS ======== Resetting the system time and date to something earlier than a project's creation time and date can cause that project's labeling information to be lost. CAUSE ===== SourceSafe uses the system date and time to determine if a file is within a valid range for a label. Manually altering the system clock to facilitate a desired date preceding the creation date of the project causes serious damage to the labeling structure of the project. RESOLUTION ========== Make sure the system clock is set to the right time before checking in files. If you need to alter the computer's system date and time, you must be careful to reset to the correct date and time before checking files in to SourceSafe. On a network server, all workstations should be synchronized to the server's time to ensure correct date/time stamping by those workstations using SourceSafe. STATUS ====== This behavior is by design. MORE INFORMATION ================ The NET TIME command is used to synchronize the time in Windows NT. The syntax is as follows: NET TIME [\\computername | /DOMAIN:domainname] /SET where \\computername is the computer to which you want to synchronize your computer's clock. If you have a domain controller, use the domain to synchronize with the domain controller. The SYSTIME utility is used to synchronize time using a Novell Netware File server. The syntax for this command can be found in Novell's Help system. STEPS TO REPRODUCE ------------------ 1. Create a new project and add some files. 2. Set the system clock back to an earlier date. 3. Add a Label to the project. 4. Check the files out from the project. 5. Set the system clock back to the current time and date. 6. Check the files in. 7. View the History of the project. RESULT: The label does not appear in the project's history. Additional query words: stamp date time ====================================================================== Keywords : kb3rdparty kbSSafe400 kbSSafe600 Technology : kbSSafeSearch kbAudDeveloper kbSSafe600 kbSSafe400 kbSSafe16bitSearch Version : :4.0,6.0 Issue type : kbprb ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.