Excel: Fractional Margins Not Accepted by Mac Daisy Link

 Last reviewed: October 31, 1994
Article ID: Q51541

SUMMARY

When using the Mac Daisy Link driver with Microsoft Excel version 2.20, you cannot enter fractional measurements (that is, .75, 1.5, 1.25) in the margins in Page Setup. This is because the Mac Daisy Link driver does not accept fractional margins in Page Setup.

To enable Excel to print with fractional margins, do the following:

  1. Choose another printer driver from the Chooser (ImageWriter, LaserWriter, etc.).

  2. Enter the fractional margins in Page Setup.

  3. Reselect the Mac Daisy Link driver from the Chooser.

Microsoft is researching this problem and will post new information here as it becomes available.

KBCategory: kbother
KBSubcategory:

Additional reference words: 2.20

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 31, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.