DOC: IOConfig Alias-offset Example Incorrect

ID: Q163360

The information in this article applies to:

SUMMARY

The Windows 95 DDK contains the following IOConfig alias-offset example:

The following example shows the use of a Type 1 I/O range value in an IOConfig item. This specifies 16 IO port regions of 1 byte each, where each region starts at x2E8 where x is 0-Fh. IOConfig=2E8-2E8(FFFF:4:)
The example should be:

IOConfig=2E8-2E8(FFFF:1000:) in order to reserve IO regions of x2E8, where x is 0-Fh. Windows 95 actually takes the high byte of the low word of the alias-offset parameter, and assumes that the low byte is zero. So, any alias-offset of 10xxh is treated as 1000h.

When you try to add a new hardware device that requires a base address that is the same as an alias of another hardware device previously installed, Windows 95 reports a conflict. However, when you run the Windows 95 Conflict Troubleshooter and use Device Manager to manually set the configuration for the conflicting device, no conflicts are reported.

Additional query words: 4.00 


Keywords          : kbprg NTDDKKMode 
Version           : 4.0
Platform          : WINDOWS 
Issue type        :

Last Reviewed: March 4, 1999