DOCUMENT:Q63219  24-OCT-1999  [win95x]
TITLE   :"386 Display Type Mismatch" Error Starting MS-DOS Apps
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:WINDOWS:3.0,3.0a,3.1,3.11
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows versions 3.0, 3.0a, 3.1, 3.11 
-------------------------------------------------------------------------------

SUMMARY
=======

You may have difficulty running non-Windows-based applications if you install
Microsoft Windows for a CGA display on a system that has a VGA card. If you are
running in 386 enhanced mode, you may receive the following error message:

   386 Display Type Mismatch

Non-Windows-based applications run correctly in standard and real modes until you
switch away from the application and then return to the application.

MORE INFORMATION
================

If you have an unsupported VGA graphics card and you installed Windows 3.0 or
3.1 for CGA, the following steps may allow you to run non-Windows-based
applications in enhanced mode:

1. Install Windows 3.0 or 3.1 for VGA. (This provides the Windows executable
   files with a VGA virtual device driver. This device driver is internal and
   cannot be added later). Starting Windows at this point causes it to stop
   responding (hang).

2. Run Setup from the hard disk, and change the graphics resolution to CGA. Do
   this by going to the directory where Windows is installed and typing "setup"
   (without the quotation marks).

3. Start Windows and run SYSEDIT (or another text editor).

4. Open the SYSTEM.INI file for editing.

5. In the [boot] section, change the line

        386grabber=cga.gr3

   to

        386grabber=vga.gr3

6. In the [386Enh] section, change the line

        display=vddcga.386

   to

        display=*vddvga

7. Save the changes to SYSTEM.INI and restart Windows.

This procedure also works for an unsupported EGA video display. Use the same
steps and substitute EGA wherever it references VGA. The line in the [boot]
section becomes 386grabber=ega; for Windows 3.0, the setting in the [386Enh]
section should be:

        display=*vddega

for Windows 3.1, setting should be:

        display=vddega.386

Additional query words: 3.00 3.10 3.00a 3.11 KBHW

======================================================================
Keywords          :  
Technology        : kbWin3xSearch kbZNotKeyword3 kbWin300 kbWin300a kbWin310 kbWin311
Version           : WINDOWS:3.0,3.0a,3.1,3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.