DOCUMENT:Q71731 30-OCT-1999 [win95x] TITLE :Installing Windows Version 3.0 on IBM L40 Laptop PRODUCT :Microsoft Windows 95.x Retail Product PROD/VER:WINDOWS:3.0,3.0a OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows versions 3.0, 3.0a ------------------------------------------------------------------------------- SUMMARY ======= There are several special steps that must be taken to successfully install Windows on the IBM L40 386SX Laptop. If these steps are not taken, the following may occur: - The system stops responding (hang) during setup. - The system hangs during bootup when HIMEM.SYS is executed. - Windows exhibits erratic behavior. This information applies to Microsoft Windows versions 3.0, and 3.0a. This information does not apply to later versions of Windows. MORE INFORMATION ================ Keyboard -------- The IBM L40 386SX Laptop has a detachable numeric keypad that must be attached when the Setup program is run. If the keypad is not attached, Setup will detect an 84-key keyboard, rather than the 101-key keyboard. In this case, the "Enhanced 101 or 102 key US" choice should be selected. Accepting the 84-key choice will not allow the keypad to be used with Windows, if it is attached later. Mouse ----- "Microsoft or IBM PS/2 Mouse" should be selected in Setup. HIMEM.SYS --------- The IBM L40 is a PS/2, but it does not have a Micro Channel bus. The L40 uses the AT-style bus, which causes HIMEM.SYS to use A20 handler number 1. This will cause the system to hang, or cause repeated beeps, during bootup. The IBM L40 requires HIMEM.SYS to use handler number 2. The following line needs to be in the CONFIG.SYS file: DEVICE=HIMEM.SYS /M:2 L40 Suspend/Resume Option ------------------------- The L40 has a Suspend/Resume option, which allows you to close the machine to change batteries and retain work in memory. This option will cause erratic behavior in Windows unless the following procedure is performed: 1. The file PM_BIOS.386 must be in the WINDOWS\SYSTEM directory. This file can be found on the IBM Reference Disk accompanying the L40. 2. The following lines must be added to the [386ENH] section of the SYSTEM.INI: EMMExclude=E000-EFFF DMABufferSize=064 Device=PM_BIOS.386 According to IBM, Windows should function normally on the L40 Laptop after these steps have been taken. The IBM products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability. Additional query words: 3.00 win30 3.00a lap top lap-top ====================================================================== Keywords : Technology : kbWin3xSearch kbZNotKeyword3 kbWin300 kbWin300a Version : WINDOWS:3.0,3.0a ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 1999.