DOCUMENT:Q83735 11-OCT-1999 [win95x] TITLE :LVMD.386 and LMOUSE.DRV Not Installed with Windows 3.1 PRODUCT :Microsoft Windows 95.x Retail Product PROD/VER:WINDOWS:3.1,3.11 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows versions 3.1, 3.11 ------------------------------------------------------------------------------- SUMMARY ======= When Express Setup is used to upgrade Microsoft Windows 3.0a to Microsoft Windows 3.1 or 3.11 on a system with a Logitech mouse, the LMOUSE.DRV file and the virtual driver file LVMD.386 are not installed. This article describes the procedure for installing these drivers. MORE INFORMATION ================ To install these drivers: 1. At the MS-DOS command prompt, copy EXPAND.EXE from Disk 3 of the Windows setup disks to the root directory on drive C. For example, if disk 3 is in drive A, you would type the following and press ENTER: copy a:expand.exe c:\ 2. Delete the LMOUSE.DRV file in the Windows\SYSTEM subdirectory. To do this, use the MS-DOS CD command to change to the Windows\SYSTEM subdirectory, then issue the MS-DOS DEL command. The following is an example (press ENTER at the end of each line): cd\windows\system del lmouse.drv 3. If you are using 1.2 MB or 1.44 MB Windows setup disks, insert Disk 2. If you are using 720K disks insert Disk 4. 4. Type the following commands (press ENTER at the end of each line): expand a:lmouse.dr_ c:\windows\system\lmouse.drv expand a:lvmd.38_ c:\windows\system\lvmd.386 5. Edit the SYSTEM.INI file with a standard ASCII text editor (such as Notepad or the Microsoft MS-DOS version 5.0 Editor) and make sure the following two lines exist under the correct section header. The following line should already exist: [boot] MOUSE.DRV=LMOUSE.DRV The following line replaces MOUSE=*VMD: [386Enh] MOUSE=LVMD.386 NOTE: If you run Setup from inside of Windows to switch from any available mouse selection and switch to Logitech Mouse, then LMOUSE.DRV and LVMD.386 are copied to your system from the Windows disks. LMOUSE.COM is not copied. LMOUSE.COM is necessary for mouse support for non-Windows-based applications and should be loaded before starting Windows. Use the following command line to expand LMOUSE.COM from the Windows disks: expand a:\lmouse.co_ c:\windows\lmouse.com Additional query words: 3.10 3.11 upgrade update set up ====================================================================== Keywords : Technology : kbWin3xSearch kbZNotKeyword3 kbWin310 kbWin311 Version : WINDOWS:3.1,3.11 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 1999.