Excel: Specifying Font Size in Header/Footer in 2.20

Last reviewed: October 31, 1994
Article ID: Q48155

SUMMARY

Page 269 of the "Microsoft Excel Reference" version 2.2 manual incorrectly states that to enter a font size for the header or footer, type the following, where "num" is the font size in points:

   &"num"

The font size is ignored if this method is used. To specify a font size, type "&num" (with no quotation marks), as follows:

   &num

KBCategory: kbother
KBSubcategory:
Additional reference words: 2.20

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: October 31, 1994
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.