DOCUMENT:Q85749 07-NOV-1999 [win95x] TITLE :WRK Translation Buffer Information Is Incorrect PRODUCT :Microsoft Windows 95.x Retail Product PROD/VER:WINDOWS:3.1 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows 3.1 ------------------------------------------------------------------------------- SUMMARY ======= Page 269 of the "Microsoft Windows Resource Kit" (WRK) guide for Windows 3.1 gives inaccurate instructions for placing the 386 enhanced mode translation buffers in the upper memory area (UMA). Paragraph 3 of the section titled "Freeing Conventional Memory in 386 Enhanced Mode" states: Then add an x= switch to the EMM386 line in the CONFIG.SYS to exclude the unused UMB ranges. Other information in this section indicates that Windows 3.1 uses these excluded ranges for placement of the translation buffers. This is incorrect; any UMAs excluded by an upper memory block (UMB) provider will also be excluded from use by Windows 3.1. MORE INFORMATION ================ Windows running in 386 enhanced mode queries any UMB provider (such as EMM386.EXE, QEMM, and 386Max) for information about the UMB area. Every UMB provider creates a data structure that contains the following information in 4K granularity (that is, every 4K is marked as one of the following): 1. Part of a UMB Something has been loaded into this address range. 2. Part of an EMM page frame The memory is part of a LIM 4.0 page frame. 3. Part of an EMS page frame The memory is part of a LIM 3.2 page frame. 4. Usable This is the region that is "free." All areas marked by an I= parameter in EMM386.EXE, which are not actually used, will be marked as usable. 5. Unusable This is the region that is either RAM, ROM, or specifically excluded (for example, the X= parameter in EMM386.EXE). 6. Unknown All addresses that are not scanned will be marked as Unknown. This region will be scanned by Windows as it normally would. Under Microsoft Windows 3.0, only numbers 1 and 3 are looked at. Consequently, address ranges that need to be excluded on the command line for the UMB provider should also be excluded in the [386Enh] section of the SYSTEM.INI with an EMMExclude statement. Under Microsoft Windows 3.1, the whole structure is looked at and assumed to be valid. As a result, the following entries in the [386Enh] section of the SYSTEM.INI are ignored, except where they do not conflict with the structure created by the UMB provider: 1. EMMINCLUDE 2. EMMEXCLUDE 3. RESERVEDHIGHAREA 4. USEABLEHIGHAREA 5. IGNOREINSTALLEDEMM 6. NOEMMDRIVER 7. EMMPAGEFRAME For example, if EMM386.EXE is installed with the line DEVICE=C:\Windows\EMM386.EXE NOEMS then the line "EMMInclude=B000-B7FF" would be used by Windows 3.1 because the B000 region is not scanned by EMM386.EXE. However, the line "EMMExclude=D800-DFFF" will be ignored because this region is scanned by EMM386.EXE. Additional query words: 3.10 3.1 ====================================================================== Keywords : Technology : kbWin3xSearch kbZNotKeyword3 kbWin310 Version : WINDOWS:3.1 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 1999.