DOCUMENT:Q137272  18-DEC-2000  [win95x]
TITLE   :Damaged Cabinet File on Non-DMF MS Plus! Disk Set
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows 95 
 - Microsoft Plus! for Windows 95 
-------------------------------------------------------------------------------

SYMPTOMS
========

When you try to install Microsoft Plus! for Windows 95 using a 3.5-inch standard
(non-DMF) 1.44-MB disk set, you may receive the following error message when
Setup reaches eight percent complete:

   The compressed file '<drive>:\plus_1.CAB' cannot be decompressed and
   may be corrupted.

After Setup closes and you restart the computer, you may receive the following
error message when you try to perform a DriveSpace operation:

   The compression driver that is currently loaded is incompatible with your
   version of Windows compression. ID Number: DRVSPACE484

In addition, you may receive "Out of memory" error messages if your Windows swap
file is located on a compressed drive, and the Disk Compression status line on
the Performance tab in System properties may report that compressed drives are
being access in MS-DOS Compatibility mode.

CAUSE
=====

The cabinet (.cab) file located on disk 1 is damaged. The disk sets known to
have this problem have a disk assembly number of 320-051-013. The disk assembly
number is located in the lower right corner of the disk, above the words "All
rights reserved."

The damaged cabinet file prevents Setup from copying the protected-mode
DriveSpace 3 driver (Drvspacx.vxd) to the hard disk, and causes Setup to fail.
When you restart your computer, the real-mode DriveSpace 3 driver is loaded,
causing your compressed drives to use MS-DOS Compatibility mode. This driver is
incompatible with the Windows 95 version of DriveSpace that is currently
installed, preventing you from running DriveSpace in Windows 95.

RESOLUTION
==========

Remove the Program Files\Plus! folder that was created by Setup, and then
reinstall Microsoft Plus from a CD-ROM, a 3.5-inch DMF disk set, or a 3.5- inch
standard (non-DMF) disk set that does not have this problem. To obtain a
replacement non-DMF disk set that does not have this problem, please contact
Microsoft Product Support.


If you are using DriveSpace and you cannot reinstall Microsoft Plus! from a
CD-ROM, a 3.5-inch DMF disk set, or a 3.5-inch standard (non-DMF) disk set that
does not have this problem right away, restore the Windows 95 DriveSpace files
that were replaced by Microsoft Plus! Setup before you use Windows 95. To do so,
start your computer at a command prompt, change to the drive containing Windows
95, and type the following commands. Press ENTER after each command.

NOTE: These commands assume that your Windows folder is named Windows. If your
Windows folder is named something else, substitute the name of your Windows
folder in the following commands.

   cd \windows\command
   copy drvbin.w95 drvspace.bin /y
   copy dblbin.w95 dblspace.bin /y
   copy drvsys.w95 drvspace.sys /y
   copy dblsys.w95 dblspace.sys /y
   cd \windows\system\iosubsys
   copy drvvxd.w95 drvspacx.vxd /y
   cd\ 
   attrib *.w95 -s -h -r
   attrib *.bin -s -h -r
   copy drvbin.w95 drvspace.bin /y
   copy dblbin.w95 dblspace.bin /y

NOTE: Depending on the version of MS-DOS or Windows that was originally used to
compress your drive, some of the .w95 files referenced in the above commands may
not exist. If you receive a "File not found" error message after typing one of
the above commands, try typing the command again to see if you typed it
correctly. If you receive the same error message again, move on to the next
command.

If the drive that contains the Windows folder is not also the physical boot
drive, change to the physical boot drive and type the following commands. Press
ENTER after each command:

   cd\ 
   attrib *.w95 -s -h -r
   attrib *.bin -s -h -r
   copy drvbin.w95 drvspace.bin /y
   copy dblbin.w95 dblspace.bin /y

After you type these commands, restart your computer.

Additional query words: corrupt

======================================================================
Keywords          :  
Technology        : kbWin95search kbGamesSearch kbPlusSearch kbZNotKeyword3 kbPlus95

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.