DOCUMENT:Q135037 17-DEC-2000 [win95x] TITLE :How to Connect a LaserDisc Player Using MCI Driver PRODUCT :Microsoft Windows 95.x Retail Product PROD/VER: OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows 95 ------------------------------------------------------------------------------- SUMMARY ======= This article describes how to connect a Pioneer LaserDisc player using the MCI Pioneer LaserDisc device in Windows 95. MORE INFORMATION ================ To connect a LaserDisc player using the MCI Pioneer LaserDisc device, the LaserDisc player must meet the following criteria: - It must be a LaserDisc player manufactured by Pioneer. - The connecting cable must be a Pioneer cable (part number CC-12 or CC-13) to connect to a 9-pin or 25-pin serial port. The Pioneer CC-12 and CC-13 cables are RS-232 cables that connect Pioneer's LD-V8000, LDV4000, CLD-V2600, CLD-V2400, LD-V2200, or LD-V4200 LaserDisc player, and the LC-330 AutoChanger to a computer with a 9- or 25-pin male D-sub-connector RS-232 port. - The LaserDisc player must have Level III capabilities. LaserDisc Player Control Methods -------------------------------- Level I - Manual Control: In Level I, the player is controlled using the remote control, the front panel buttons, or a laser barcode reader. All current Pioneer industrial LaserDisc players support Level I. Level I alone does not support computer control. Level II - Internal Program Control: The Pioneer LD-V6000A (discontinued) and the LD-V8000 are the only models that currently support Level II. In this level, programs encoded on a LaserDisc are sent to the player's memory. Level II program codes can also be sent to the player using the remote control or by a computer. This configuration could communicate with a computer, but would not need the MCI Pioneer LaserDisc device driver. If the device driver were installed, it would overwrite the information encoded on the LaserDisc, and would probably cause the connection to be dropped. Level III - External Computer Control: In Level III, commands to control the player are sent through an RS-232 cable from a computer or controller. The MCI Pioneer LaserDisc device driver is required for this configuration. Installing the Pioneer LaserDisc (Media Control) Device ------------------------------------------------------- To install the Pioneer LaserDisc device driver, follow these steps: 1. In Control Panel, double-click the Multimedia icon. 2. On the Advanced tab, double-click Media Control Devices. 3. Click Pioneer LaserDisc Device (Media Control), and then click Properties. 4. Click the Use This Media Control Device option, and then click Settings. 5. Click the appropriate communications port option, and then click OK. 6. Click OK, and then click OK again. 7. When you are prompted to restart your computer, do so. Additional query words: videodisc laser disc ====================================================================== Keywords : Technology : kbWin95search kbZNotKeyword3 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2000.