Disabling the POSIX Subsystem

Last reviewed: May 7, 1997
Article ID: Q101270
The information in this article applies to:
  • Microsoft Windows NT operating system version 3.1
  • Microsoft Windows NT Advanced Server version 3.1

There is little to gain by disabling the POSIX subsystem in Windows NT because POSIX is only started once a POSIX-based application is started. There are no memory savings or performance increases.

If you want to disable the POSIX subsystem, you can do so by going to the following subkey and deleting the POSIX value:

   HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\
   Session Manager\Subsystems

Note: The same is true for the OS/2 subsystem; until an OS/2-based application is started, the OS/2 subsystem server is not loaded.


Additional query words: prodnt
Keywords : kb3rdparty nthowto ntposixap
Version : 3.1
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 7, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.