Err Msg: Tape Drive Error Detected with 4MM DAT Tape Device

Last reviewed: August 13, 1997
Article ID: Q126458

The information in this article applies to:

Microsoft Windows NT Workstation versions 3.5, 3.51, and 4.0
Microsoft Windows NT Server versions 3.5, 3.51, and 4.0

SYMPTOMS

When you run Windows NT Backup (NTBACKUP.EXE) with an Archive Python 4MM DAT tape device, the following error message appears:

   Tape Drive Error Detected
   A tape device has been detected, and the tape driver started. However,
   the tape device is not responding. Check that tape device power is on
   and cables are properly connected.

CAUSE

This problem occurs if the CMOS setting for SCSI Disconnect is disabled.

RESOLUTION

To correct this problem, modify the computer's CMOS settings to enable SCSI Disconnect.

Additional query words: prodnt 3.50 bios computer system configuration
4 four 3.51 4.00 MM millimeter

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: August 13, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.