Floorplan+ for Windows "Divide By Zero or Overflow Error"

Last reviewed: May 8, 1997
Article ID: Q102542

The information in this article applies to:
  • Microsoft Windows NT operating system, version 3.1
  • Microsoft Windows NT Advanced Server, version 3.1

SYMPTOMS

When you run Floorplan+ for Windows with Windows NT, you may receive the following error message when you start the application:

   Divide By Zero or Overflow Error

This error occurs when you move the mouse pointer as the application starts.

CAUSE

This error seems to occurs as the application tries to determine the initial location of the mouse pointer. If the mouse is left in a position over the drawing area when you start the application, you receive the error mentioned above.

RESOLUTION

To work around this problem, move the mouse pointer out of the application window (to the edge of the screen) as the application starts.


Additional query words: prodnt
Keywords : kb3rdparty kbbug3.10 nt16ap
Version : 3.1
Platform : WINDOWS


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 8, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.