DOCUMENT:Q171267  09-AUG-2001  [winnt]
TITLE   :How to Install Remote Access Service in Windows NT 3.51
PRODUCT :Microsoft Windows NT
PROD/VER:WINDOWS:3.51
OPER/SYS:
KEYWORDS:kbenv

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows NT Workstation version 3.51 
-------------------------------------------------------------------------------

SUMMARY
=======

This article describes how to install Remote Access Service (RAS) in Windows NT
Workstation version 3.51.

MORE INFORMATION
================

To install RAS, follow these steps:

1. In Control Panel, double-click Network.

   NOTE: If you have not set up networking on your computer, you are prompted to
   do so at this time. Click Yes to install networking, and then continue
   installing RAS.

2. Click Add Software.

3. In the Network Software box, click Remote Access Service, and then click
   Continue.

4. Click the appropriate port, and then click Configure.

   NOTE: If you have not installed a modem, you are prompted to do so at this
   time. Click Yes to install your modem, and then continue installing RAS.

5. In the Attached Device box, click the appropriate modem.

6. In the Port Usage box, click the appropriate option, and then click OK.

7. Click Network, verify your network configuration, and then click OK.

8. Click Continue, and then click OK until all dialog boxes are closed. Restart
   the computer when prompted.

To start the Remote Access Server Service, follow these steps:

1. In the Remote Access group, double-click Remote Access Admin.

2. On the Server menu, click Start Remote Access Service.

To connect using Remote Access Service, follow these steps:

1. In the Remote Access group, double-click Remote Access.

2. If you have not created a phone book entry, you are prompted to do so. If you
   have created a phone book entry, click New.

3. Type the name and phone number.

4. To configure the modem, X.25, ISDN, network, or security, click Advanced.

5. Click OK to save the entry.

6. In the Remote Access dialog box, click the appropriate entry, and then click
   Dial.

======================================================================
Keywords          : kbenv 
Technology        : kbWinNTsearch kbWinNTWsearch kbWinNT351search kbWinNTW351search kbWinNTW351
Version           : WINDOWS:3.51
Issue type        : kbhowto

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2001.