DOCUMENT:Q154988 13-FEB-2002 [winnt] TITLE :Troubleshooting Fast EtherLink and EtherLink III (R) Adapters PRODUCT :Microsoft Windows NT PROD/VER::3.5,3.51 OPER/SYS: KEYWORDS:kb3rdparty ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows NT Workstation versions 3.5, 3.51 - Microsoft Windows NT Server versions 3.5, 3.51 ------------------------------------------------------------------------------- SUMMARY ======= When you are have problems installing 3com Etherdisk drivers for Etherlink and the Etherlink III (R) Bus Master Adapters, the troubleshooting guide below will help you with a smooth installation. If the adapter diagnostic tests fail, the adapter might not be defective. Check the following: - Make sure the adapter is completely seated in its slot. Review the installation instructions in the appropriate adapter guide. - If you are running the Group 2 test, make sure the adapter is securely connected to a loopback plug or to a properly cabled network. - If you are running the Group 3 test, make sure the adapter is securely connected to a properly cabled network and an echo server is set up on the network. - Make sure the configuration setting for the transceiver type is correct. - Running Group 2 tests while connected to an active network can cause intermittent failures. These failures can be avoided by using a loopback plug or by connecting to an inactive network on which only the computer being tested is operating. - If you installed a twisted-pair adapter, check the LED on the back plate of the adapter. The LED should be checked only during or after the diagnostic tests have been run. The LED will be on when there is a correct connection between the adapter and the hub. The LED will flash if the polarity of the connection is swapped. - Install the adapter in another slot and run the tests again. The slot in the computer may be defective. - Install the adapter in a known, functioning computer and run the tests again. The computer in which the adapter is installed might be defective. - Try a different loopback plug. The loopback plug you are using might be defective. - Replace the failed adapter with a known working adapter with the same configuration. If the second adapter fails, something is probably wrong with the test environment, not with the adapter. MORE INFORMATION ================ For more information, please contact 3com Corporation. Additional query words: 3com Nic netcard drivers installation setup diagnostic bus master adapter ====================================================================== Keywords : kb3rdparty Technology : kbWinNTsearch kbWinNTWsearch kbWinNT351search kbWinNT350search kbWinNTW350 kbWinNTW350search kbWinNTW351search kbWinNTW351 kbWinNTSsearch kbWinNTS351 kbWinNTS350 kbWinNTS351search kbWinNTS350search Version : :3.5,3.51 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.