UltraStor Controller Stop Message Inaccessible Boot Device

Last reviewed: May 12, 1997
Article ID: Q106375

The information in this article applies to:

Microsoft Windows NT operating system version 3.1
Microsoft Windows NT Advanced Server version 3.1

SYMPTOMS

If you attempt to set up Windows NT 3.1 on an ESDI hard disk with the UltraStor 12f ESDI controller, you may receive the following STOP message:

    Stop (hex dump)
    Inaccessible_boot_device

WORKAROUND

According to UltraStor, you must upgrade the firmware to version 28001-012 and the BIOS to version 38001-010.

To order these upgrades, call UltraStor Technical Support at (510) 623-8955. If you have an EPROM burner, you can also download the micro code images from the UltraStor BBS at (510) 623-9091.

The products included here are manufactured by a vendor independent of Microsoft; we make no warranty, implied or otherwise, regarding these products' performance or reliability.

Additional query words: prodnt blue trap
Keywords : kbhw nthw ntstop
Version : 3.1
Platform : WINDOWS

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: May 12, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.