WD: How to Change Default Tabs Stops Globally in Microsoft Word

Last reviewed: February 5, 1998
Article ID: Q142099
The information in this article applies to:
  • Microsoft Word for the Macintosh, versions 6.0, 6.0.1, 6.0.1a
  • Microsoft Word for Windows, versions 6.0, 6.0a, 6.0c
  • Microsoft Word for Windows NT, version 6.0
  • Microsoft Word for Windows 95, versions 7.0, 7.0a
  • Microsoft Word 97 for Windows

SUMMARY

This article describes how to change the default tab stops so that every new document you create that is based on the Normal template will have the same default tab stop settings.

MORE INFORMATION

When you change the Default Tab Stops option in the Tabs dialog box, Word sets the default tabs stops for the current document only. New documents will not reflect the change.

When you create a new document based on the Normal template, the default tab stop settings occur every 0.5 inch. Therefore, to make certain all new documents have the same default tab settings, you must open the Normal.dot file and make the change to the template. Use the following instructions to modify your Normal template:

  1. On the File menu, click Open. Open Normal.dot (Windows) or Normal (Macintosh).

    NOTE: To determine the location of Normal.dot, click Options on the Tools menu, click the File Locations tab, and note the path in the User Templates setting.

  2. On the Format menu, click Tabs.

  3. Change Default Tab Stops to the desired value.

  4. Click OK.

  5. On the File menu, click Save.

  6. Close the template.

Now when you create a new document (based on the Normal template), the default tab stops will be based on the change just made to the Normal template.

NOTE: You can set the default tab stops in any template, following the above procedure, but instead of opening the Normal template, open the desired template and make the same changes in steps 2-5.

REFERENCES

"Microsoft Word for Windows User's Guide," version 2.0, page 179

"Microsoft Word for Windows User's Guide," version 6.0, Chapter 7 - Formatting Paragraphs, "Setting and Clearing Tab Stops" section


Additional query words: set setting changing changes stop global globally
defaulting defaults howto
Keywords : kbformat macword ntword winword word6 word7 word95 word97 wordnt kbualink97
Version : WINDOWS:6.0,6.0a,6.0c,7.0,7.0a,97;MACINTOSH:6.0,6.0.1,6.0.1a
Platform : MACINTOSH WINDOWS
Issue type : kbhowto


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: February 5, 1998
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.