DOCUMENT:Q113156  05-FEB-2002  [mspress]
TITLE   :MS-DOS 6.2 Step By Step p.xxi: Install Does Not Make Backup.
PRODUCT :Microsoft Press
PROD/VER::
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - MSPRESS Microsoft MS-DOS Step By Step (covers versions 6.0 and 6.2), Printing 1 
-------------------------------------------------------------------------------

SYMPTOMS
========

The "MS-DOS 6.2 Step By Step" (first printing) companion disk installation
program does not ask for a blank disk. This contradicts page xxi under step #3,
where the book says:

   When asked to place a new blank disk in the drive, be sure to use a disk with
   the highest capacity that your drive can handle.(For more details, refer to
   "Identifying Types of Floppy Disks," in Lesson2.)

When the installation program runs, it never asks for a blank disk.

CAUSE
=====

The installation program does not make use of a blank disk. The paragraph below
step 3 on page xxi is an error in the first printing of this book, and should be
substituted with the information below.

RESOLUTION
==========

Ignore the paragraph directly below step 3 on page xxi. This paragraph is an
error in the first printing of this book. The installation program does not make
a backup as these instructions indicate.

A copy practice disk must be created. This disk will be referenced throughout the
lessons in the book.

To create a copy practice disk, complete the following step. (Current printings
have this step included as step 4.)

   3.5 When the installation is completed, copy the practice files to a new
   floppy disk. Insert a blank, formatted disk in the drive. If you're not
   certain that the disk is formatted, follow steps 3 through 7 on page 21
   before continuing. Then type the following commands, pressing the ENTER key
   after each command. (If your floppy disk is in drive B, substitute B: for the
   A: in these commands.)

      XCOPY C:\SBS1STEP A:\SBS1STEP /S /E
      XCOPY C:\SBSLESSN A:\SBSLESSN /S /E
      XCOPY C:\SBSREV&P A:\SBSREV&P /S /E

   After you enter each command, MS-DOS asks you whether you have specified a
   file name or directory name. Press D for directory.

IMPORTANT: MS-DOS 6.2 Step By Step references the practice disk several times in
this book, so it is very important to complete the step outlined above.

STATUS
======

Microsoft has confirmed this to be a problem in "Microsoft Press MS-DOS 6.2 Step
By Step" printing 1. This problem was corrected in "Microsoft Press MS-DOS Step
By Step 6.2" printing 2.

MORE INFORMATION
================

An errata sheet is available from Microsoft Press Technical Support. The
information in the errata sheet is the same as the information provided in this
article.

Additional query words: "missing practice disk" SBS fail bad incomplete setup

======================================================================
Keywords          :  
Technology        : kbMSPressSearch
Version           : :

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2002.