DOCUMENT:Q230650  19-DEC-1999  [exchange]
TITLE   :XCON: Moving Messages from One X.400 Connector Queue to Another
PRODUCT :Microsoft Exchange
PROD/VER:winnt:4.0,5.0,5.5
OPER/SYS:
KEYWORDS:exc4 exc5 exc55

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Exchange Server, versions 4.0, 5.0, 5.5 
-------------------------------------------------------------------------------

SUMMARY
=======

The following scenario describes the situation for how to move messages from one
X.400 Connector queue to another:

Server A is in Houston, running Exchange Server 5.5 Service Pack 2, on Windows NT
4.0 Service Pack 3.
It has the following X.400 Connectors:

   X.400 Connector to Florida Cost = 1 (connected site only to Florida)
   X.400 Connector to Arizona Cost = 100 (connected site only to Arizona)

   Houston ------128 Kbps-------Florida-------T-1---------Arizona

   Arizona is the directory replication hub.
   There is no direct link between Houston and Arizona.

There are messages sitting in the queue of the X.400 Connector to Arizona, and
they are not getting delivered.

Original:
For example, If there are messages sitting in the queue to x400 connector to the
Arizona, and are not getting delivered because of any reason. This article
presents a way to move these messages to the other X400 connector to Florida
queue on the same server.

In general, this article presents a way to move messages from one X.400 Connector
queue to another X.400 Connector queue on the same server, if server has the
proper routing information.

MORE INFORMATION
================

There are two approaches you can take:

Method One
----------

1. On the X.400 Connector from which you want to move messages, change the
   address space on the X.400 Connector, and make it invalid.

2. Recalculate routing.

3. Stop and restart the Message Transfer Agent (MTA) service.

Method Two
----------

1. Delete the X.400 Connector from which you want to move messages.

2. Recalculate routing.

3. Stop and restart the MTA service.

CAUTION: If the X.400 Connector is also involved in the directory replication
topology, you must compensate for it.

Additional query words:

======================================================================
Keywords          : exc4 exc5 exc55 
Technology        : kbExchangeSearch kbExchange500 kbExchange550 kbExchange400 kbZNotKeyword2
Version           : winnt:4.0,5.0,5.5
Issue type        : kbhowto

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.