DOCUMENT:Q198406 16-MAY-2002 [winnt] TITLE :RIP Version 2 Does Not Advertise Subnet Routes PRODUCT :Microsoft Windows NT PROD/VER:winnt:4.0 OPER/SYS: KEYWORDS:kbWinNT400sp5fix ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Windows NT Workstation version 4.0 - Microsoft Windows NT Server version 4.0 - Microsoft Windows NT Server, Enterprise Edition version 4.0 ------------------------------------------------------------------------------- SYMPTOMS ======== Your Windows NT servers that are running the Routing and Remote Access Service (RRAS) Update are not advertising subnet routes for your IP networks. Instead, they are advertising one network route that summarizes the missing subnets. CAUSE ===== The Windows NT routers are using a feature known as subnet hiding. RESOLUTION ========== To resolve this problem, obtain the latest service pack for Windows NT 4.0. For additional information, please see the following article in the Microsoft Knowledge Base: Q152734 How to Obtain the Latest Windows NT 4.0 Service Pack STATUS ====== Microsoft has confirmed this to be a problem in the Microsoft products that are listed at the beginning of this article. This problem was first corrected in Windows NT version 4.0 Service Pack 5. MORE INFORMATION ================ The feature described above, subnet hiding, is expected behavior with RIP version 1. RIP version 1 does not have a field for the subnet mask of a network and does not support subnet advertisements. When advertising routes to an external network that could not possibly know the subnet mask, the subnetted routes are reduced to a single network route or a Summary Route. RIP version 2 is capable of advertising subnet masks; however, RIP version 2 may not advertise specific subnet routes when RIP version 1 routers could mistake the routes as host routes. This would be the case if the RIP version 1 router had a different network ID than the RIP version 2 router. This behavior of subnet hiding is always done with RIP version 1 and is usually done with RIP version 2. With some implementations of RIP version 2, subnet hiding can be enabled or disabled. If the announce mode is set to RIP1 or RIPv2 broadcast the subnet summarization (hiding) is always performed. You must choose RIPv2 multicast mode to disable subnet summarization. Also, the RRAS command-line utility can be used to turn this feature on or off. The following syntax example is provided: routemon ip set protocol [proto=] rip [name=] [subnetsummary=] ] Additional query words: 4.00 ====================================================================== Keywords : kbWinNT400sp5fix Technology : kbWinNTsearch kbWinNTWsearch kbWinNTW400 kbWinNTW400search kbWinNT400search kbWinNTSsearch kbWinNTSEntSearch kbWinNTSEnt400 kbWinNTS400search kbWinNTS400 Version : winnt:4.0 Hardware : ALPHA x86 Issue type : kbbug Solution Type : kbfix ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.