DOCUMENT:Q307750 20-MAR-2002 [sna] TITLE :End-User Client Does Not Connect After Configuration Change PRODUCT :Microsoft SNA Server PROD/VER:: OPER/SYS: KEYWORDS:kbDSupport kbhis2000 kbhis2000bug ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Host Integration Server 2000 ------------------------------------------------------------------------------- SYMPTOMS ======== The Host Integration Server (HIS) 2000 End User Client may not function properly after you run the SNA Resource Location Wizard to make a configuration change to the End User Client. Symptoms may vary but may include the following: - Failure to connect to an HIS 2000 or SNA Server system to obtain a host session after making a configuration change. - Configuration changes made in the SNA Resource Location Wizard revert back to their previous settings. CAUSE ===== The SNA Resource Location Wizard incorrectly sets the following registry entry to a NULL value under some circumstances: HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\SNA Server\CurrentVersion\Setup:FinalXID WORKAROUND ========== You can correct this problem by running the SNA Resource Location Wizard in Admin mode from a command prompt by using the following syntax, as documented in the HIS 2000 Readme.doc: "HICLICFG /a" (without the quotation marks) STATUS ====== Microsoft has confirmed this to be a problem in Microsoft Host Integration Server 2000. MORE INFORMATION ================ The following is an example scenario of the problem described in this article: 1. Use the SNA Resource Location Wizard to configure the End-User Client to Locate servers using Active Directory. 2. Stop SnaBase.exe (if it is running). 3. Use the SNA Resource Location Wizard to configure the End-User Client to Locate servers using a Subdomain. 4. In the Locate Servers dialog box, select Locate servers by Server Name. 5. Type one or more server names for the sponsor servers in the Locate servers by Server Name dialog box. 6. Finish the configuration and close the Wizard. 7. Start SnaBase.exe and note that Active Directory is still being used to locate HIS 2000 servers. In this example, the configuration change was not implemented when you used the SNA Resource Location Wizard in non-Admin mode because the FinalXID registry entry was incorrectly set to a NULL value. If the FinalXID registry entry was correctly defined by the SNA Resource Location Wizard, the configuration change would have taken effect. NOTE: The FinalXID registry entry was not supposed to be modified by using the steps outlined here, but its value affects whether other configuration changes are saved. Additional query words: ====================================================================== Keywords : kbDSupport kbhis2000 kbhis2000bug Technology : kbAudDeveloper kbHostIntegServ2000 Version : : Issue type : kbbug Solution Type : kbnofix ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.