DOCUMENT:Q114338  15-NOV-1999  [accother]
TITLE   :Workgroup Add-On for MS-DOS: Sharing and Loading SMARTDrive
PRODUCT :Microsoft Access Distribution Kit
PROD/VER:MS-DOS:3.11
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Workgroup Add-On for MS-DOS, version 3.11 
-------------------------------------------------------------------------------

SYMPTOMS
========

When you try to load SMARTDRV.EXE from the AUTOEXEC.BAT file after installing
the Workgroup Add-On for MS-DOS version 3.11, you may receive the following
error message:

   Unable to Use a Disk Cache on the Specified Drive

Also, when you type "smartdrv" (without the quotation marks) at an MS-DOS command
prompt, one of your hard disk drives may be missing from the SMARTDrive table
that displays disk-caching status. For example, if drive C was shared at the
last startup, the table may appear as follows:

              Disk Caching Status

   Drive   Read Cache   Write Cache   Buffering
   --------------------------------------------

   A:      Yes          No            No
   B:      Yes          No            No
   D:      Yes          No            No

CAUSE
=====

These problems occur when you are running the Workgroup Add-On for MS-DOS and
have shared an entire drive (or a directory on the drive) because the shared
drive appears to SMARTDrive as a network drive. SMARTDrive does not allow you to
cache a network resource.

WORKAROUND
==========

To work around this problem, use one of the following methods:

 - Load SMARTDrive before the NET START command in the AUTOEXEC.BAT file. This
   allows SMARTDrive to cache the drive before it appears as a network drive.

-or-

 - Set up the shared connections so that they are not saved when you exit
   Workgroup Add-On for MS-DOS but are shared after you log on again. To disable
   sharing at startup, add the /saveshare:no parameter to the end of the NET
   SHARE entry. For example, to share drive C now but not when you restart the
   system, type the following command at the MS-DOS command prompt:

   " net share cdrive=c:\ /saveshare:no " (without the quotation marks)

MORE INFORMATION
================

The aforementioned error message also appears if a DoubleSpace-compressed volume
file or the host drive for that volume is selected; however, the host or
compressed drive is still listed in the SMARTDrive table.

Additional query words: dblspace addon add-on workgroups wgao networked

======================================================================
Keywords          :  
Technology        : kbAudDeveloper kbWFWSearch kbWFW311DOS
Version           : MS-DOS:3.11

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.