DOCUMENT:Q279620 06-AUG-2002 [homegame] TITLE :MechWarrior 4 Err Msg: Invalid to Call ApplyFilters... PRODUCT :Microsoft Home Games PROD/VER:: OPER/SYS: KEYWORDS:kberrmsg kbnetwork igz kbimu msgame ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft MechWarrior 4: Vengeance ------------------------------------------------------------------------------- SYMPTOMS ======== When you attempt to connect to Zone.com from Microsoft MechWarrior 4: Vengeance, the ZoneMatch button may be unavailable, or you may receive one of the following error messages when you click ZoneMatch: - STOP: Invalid to call ApplyFilters when no game list has been created. - TCP/IP may not be enabled. CAUSE ===== This behavior can occur if one of the following conditions is true: - The Znmatch.dll and Zonenet.dll files are not registered properly on your computer. - The TCP/IP network protocol is not installed on your computer. RESOLUTION ========== To resolve this issue, use the appropriate method for the error message that you received. STOP: Invalid to Call ApplyFilters When No Game List Has Been Created --------------------------------------------------------------------- To resolve this issue, manually register the Znmatch.dll and Zonenet.dll files: 1. Click Start, and then click Run. 2. In the Open box, type the following line (including the quotation marks), and then click OK regsvr32 ":\program files\microsoft games\mechwarrior vengeance\znmatch.dll" where is the drive letter of the hard disk on which MechWarrior 4 is installed. 3. When you receive the message stating that the Znmatch.dll file was registered successfully, click OK. 4. Click Start, and then click Run. 5. In the Open box, type the following line (including the quotation marks), and then click OK regsvr32 ":\program files\microsoft games\mechwarrior vengeance\zonenet.dll" where is the drive letter of the hard disk on which MechWarrior 4 is installed. 6. When you receive the message stating that the Zonenet.dll file was registered successfully, click OK. TCP/IP May Not Be Enabled ------------------------- To resolve this issue, install the TCP/IP network protocol: 1. Click Start, point to Settings, and then click Control Panel. 2. Double-click Network. 3. On the Configuration tab, click Add. 4. In the "Click the type of network component you want to install" box, click Protocol, and then click Add. 5. In the Manufacturers box, click Microsoft. 6. In the Network Protocols box, click TCP/IP. 7. Click OK, and then click OK again. 8. When you are prompted to restart the computer, click Yes. Additional query words: 4.00 msgame mech warrior apply filters ====================================================================== Keywords : kberrmsg kbnetwork igz kbimu msgame Technology : kbGamesSearch Version : : Issue type : kbprb ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.