DOCUMENT:Q107135 21-NOV-1999 [msdos] TITLE :Using a RAM Drive to Enhance Performance of DISKCOPY PRODUCT :Microsoft Disk Operating System PROD/VER:MS-DOS:6.2,6.21,6.22 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft MS-DOS operating system versions 6.2, 6.21, 6.22 ------------------------------------------------------------------------------- SUMMARY ======= In MS-DOS 6.2 and later, the DISKCOPY command uses your hard disk drive to temporarily store the data copied from the source disk. This enables single- pass disk copies. If you install a RAM drive, you can increase the performance of this operation. MORE INFORMATION ================ DISKCOPY uses the location defined by the SET TEMP statement to determine where the data from the source disk should be temporarily stored before it is written to the destination disk. If you install a RAM drive and define it as your temporary (TEMP) directory, you can redirect the data accessed from the source disk into RAM, thus eliminating the time required for the system to perform read and write operations to the hard disk drive. To do this: 1. Set up a RAM drive in your CONFIG.SYS file using the following parameters: " device=c:\dos\ramdrive.sys 1480 /e " (without the quotation marks) NOTE: Make sure the RAM drive is large enough to hold all data from the largest floppy disk drive on your system. (The size given here sets up a 1.44-megabyte RAM drive. 2. In your AUTOEXEC.BAT file, change the SET TEMP line to point to the RAM drive as follows " set temp=:\ " (without the quotation marks) where is the drive letter assigned by the system to the new RAM drive. The performance gain is not significant on high performance systems with fast processors and hard disk drives; however, it does increase the overall speed of this process on older systems. Additional query words: 6.22 6.20 ====================================================================== Keywords : Technology : kbMSDOSSearch kbMSDOS621 kbMSDOS622 kbMSDOS620 Version : MS-DOS:6.2,6.21,6.22 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 1999.